SURFACE MATERIALS
All types of coatings may be applied over the surface materials chosen. Laminates, and if required fire-proven laminates re used.
TECHNICAL PROPERTIES OF DAFADOOR FIRE RESISTANT DOORS
THICKNESS
The completed thickness of doors vary between 43-47 mm depending on the material chosen.SURFACE MATERIALS All types of coatings may be applied over the surface materials chosen. Laminates, and if required fire-proven laminates re used.
INNER FILL MATERIALS
According to the time of resistance of fire, using materials that have different properties. (30 min - 45 min. - 60 min. - 90 min.)
ACCESSORY
There are also door closer with fire detectors, lock, panic handle, inflammable flyers made available at the users option.
DETERMINATION OF WIDTHS OF THEDOORS TONGUED (GERMEN) DOORS THE DOORS WITHOUT TONGUES (POMMELDOORS)
DETERMINATION OF THEDOOR HEIGHTS
The distance from the upper tongue to the floor(C) is measured where the cases are availableand the construction opening without floor (D)is measured or if the floor has been constructed,the opening upto the top of the (E) is measuredwhere the cases are not available.Door working tolerances and case installing tolerances are not deducted in the measurements.The floor covering thickness to be laid over thefloor are seperately notified in accordance withthe rooms.
DAFADOOR DOOR APPLICATION TO THE TONGUED STEEL SHEET CASES
THE SUBJECTS TO BE CONSIDERED WHENTAKING THE MEASUREMENTS FOR THEDOORS, ON THE STEEL SHEET CASESWITH OR WITHOUT TONGUES AVAILABLE
DETERMINATION OF THE DOOR WIDTH
1.Case tongue depth (T) 2.Measurement from the tongue to tongue (A)
DETERMINATION OF THE DOOR HEIGHT
1.Measurement from the upper tongue to thelock bolt middle axis (LK)
2.Measurement of the completed floor from the upper tongue (B).When determination of dimensions has beendone in imconplete floors, this situation should be specified specially. Unless otherwisespecified,our firm determines the height of thedoor by calculating 7 cm.difference between the complete floors and manufactures the doorsaccordingly.
SUBECTS REQUIRED TO BE INFORMEDFOR
MANUFACTURING
*Brand and type of the lock to be used.*On the doors to be manufactured for the casesavailable,the measurement method ofthe distance between the mid-point of the door lock bolt and the upper tongue (LK)has beenindicated in the previous pages.
*The central measurement of the knob handled(figure4).(Kb 60 or 70 mm)*If additional locks shall be installed to the outside doors,the brand and type of the lock.